B
Quantum analogs compare the difference in sound inputs essay example
This paper has been submitted by a student. This is not an example of the work written by professional writers.

Quantum analogs compare the difference in sound inputs

Introduction

The main aim of this experiment is to compare the difference in sound inputs. Sound is to be input to a speaker and the sound produced by the speaker detected by a microphone. The sounds injected into the speaker and that detected by the microphone are to be compared. An oscilloscope is to be used to measure the levels of the two and compare them. A tube is used to confine the sound waves that travel from the speaker to the microphone.

The tube here acts like a container with air particles in it. The air particles are made to vibrate by the sound, producing regions of compressions and rarefactions as shown below:

These regions are what enable the sound to propagate from one end of the tube to another. This phenomenon is called air resonance [1]. Another good example of air resonance is when one blows air into an empty bottle with one of its end closed. When one blows air into the mouth of the bottle, a pressure wave is set just at the top of the mouth. The pressure wave enables air particles present in to vibrate uniformly hence producing a sound. If one blows harder, the sound becomes louder. However, the frequency of sound produced only depends on the size of the container and its shape.

Historically, the acoustic resonator was created in the 1850s using the air resonance principle. Herman Helmholtz, a scientist from Germany what is currently considered a powerful scientific instrument. The acoustic resonator uses the principle of using pressure to move air. However, instead of producing sound, this instrument detects it. The design by the scientists was such that it was able to detect a specific frequency as desired by the one operating it. The sound on that frequency could then be amplified greatly. Another important feature that the instrument had was based on the fact that it is able to extend the time period of a tone that has been produced by a sound source so that it could be heard for longer if the frequency is detectable by the ear.

The concepts above form part of a wide range of other concepts known as Acoustics. This field has enabled the building of spherical resonators that can be used in various applications. One such application is for the modeling of the hydrogen atom. Hydrogen is considered the most basic atom which, if modeled and studied through experiments, can be used to predict the behaviors of other elements. This is because it contains all basic parts of an atom which are the electron, proton, and the neutrons. The study of the hydrogen atom has led to the discovery of nuclear power. Splitting an atom causes the release of a vast amount of energy whereas combining atoms needs a lot of energy [3]. Since it is difficult to split and hydrogen atom physically in a normal lab, it is easier to model an atom, using a resonator, and split the resonator.

It should be noted that both the wave function and wave sound of the electron gives the solutions of the wave equation to describe a delocalized object (Lloyd, 1996). However, the aspect that is described is different.

There is also a software program that uses quantum Analogs apparatus to measure spectra. The program is based on sound card. It helps in measuring spectra in all amplitude and resonators in the “molecule” and the “atom” (Experimentalphysik II – Oberflächenphysik: SpectrumSLC, 2018).

Theory

As noted, resonance only occurs whenever one manages to develop a standing wave inside a closed tube. A standing wave is formed when two waves of similar frequency travel in opposite directions and interfere both constructively and destructively. Within a closed tube, the sound wave sent inside is reflected back by the closed end and hence the wave is the same which means it has the same frequency. However, other conditions have to be satisfied. One of them is that the length of the tube has to be an integer factor of the wavelength of the sound wave. This means that;

Where f if frequency and n = 1,2,3,4,….. L is the length of the tube. This way, the reflected wave will interfere with the incident one to form nodes and antinodes as shown below:

At the nodes, the two waves completely interfere destructively whereas, at the antinode, they interfere constructively. A standing wave is called that way because it is stationary. As noted above, the incident wave should start exactly at the opening of the tube. Another thing to note is that the diameter of the opening matters a lot. The smaller, the better.

The wave equation can be modeled and used to describe a standing wave. A one dimension wave equation can be sufficient. The equation below shows the one dimension wave equation.

If this equation is solved, one can effectively determine how the disturbance or air particles propagate outwards from their original positions outwards. The propagation occurs at a fixed speed but is possible towards all directions in space. However, the one dimension wave equation only considers a specific direction. There exists a three dimension wave equation which was formulated by Euler, 10 years after the formation of the one dimension equation. Euler figured out a way to solve for all wave parameters in all spatial directions.

Most of the people are in a position to manipulate concrete solution instead of just equations encouraging explorations and at the same enhances conceptual understanding. The experiment manipulates equations that affect location changes of a semiconductor (Wertz, 2012). Having the capacity to differ the area or state of a physical object and look the band-gap changes, this encourages a more extensive scope of experimentation and may even prompt a sort of “instinct” that is normally accessible just to those for whom conditions have their very own existence.

Experimental Method

Experiment 1: Standing sound Waves in a Tube

Tube pieces are connected to add to the length of the tube. Each time a tube piece is added, the speaker and microphone are put at each end and the readings on the oscilloscope taken. The frequency of the sound is varied at the speaker for a wide range starting from a low frequency of 100 Hz. It is expected that the readings are not the same due to the change in length the tube and frequency of the sound. Each length has a different resonance frequency. The resonance frequency for a certain length would not be the same for another length of the tube. As the frequency is increased, the wavelength of the wave too changes (decreases). To tell that resonance has been reached, the amplitude of the sound wave as shown by the oscilloscope should be zero showing that destructive interference has occurred.

Experiment 2: Modeling a hydrogen atom with a spherical resonator

The equipment have been set up in a manner that allows us to use the spherical resonators that represent hydrogen atoms, to determine resonance frequencies [2]. Data about the angular momentum quantum numbers of the resonators can be found too. We do this by starting from a low frequency of around 100 Hz which is increased step by step up to 8 kHz. The change in amplitude is then observed and so is the change in sign. From this, we can determine the angles where the amplitude is observed to be zero and those where the amplitude is maximum.

Experiment 3: Broken Symmetry in the Spherical Resonate and Modeling a Molecule

This experiment tries to examine the impact of the splitting of quantum states. The spherical cavity of the modeled molecule will be split symmetrically and the results studied.

References

Experimentalphysik II – Oberflächenphysik: SpectrumSLC. (2018). Uni-kassel.de. Retrieved 7 March 2018, from https://www.uni-kassel.de/fb10/institute/physik/forschungsgruppen/oberflaechenphysik/quantum-analogs/spectrumslc.html

Lloyd, S. (1996). Universal quantum simulators. Science, 1073-1078.

We will write a custom essay on
Quantum analogs compare the difference in sound inputs
specifically for you for only $15.90 $12/page!

Matzdorf, R. (2009). Quantum Analogs–Acoustic Experiments Modeling Quantum Phenomena.

Wertz, J. (2012). Electron spin resonance: elementary theory and practical applications. Springer Science & Business Media.

This Essay on "Quantum analogs compare the difference in sound inputs" was written and submitted by your fellow student. You are free to use it for research and reference purposes in order to write your own paper; however, you must cite it accordingly.
Please send request the removal if you are the copyright owner of this paper and no longer wish to have your work published on EduPRO.

EduPRO. (05/02/2021) Quantum analogs compare the difference in sound inputs. Retrieved (09/14/2021) from https://edupro.cc/examples/quantum-analogs-compare-the-difference-in-sound-inputs/
"Quantum analogs compare the difference in sound inputs." EduPRO, 05/02/2021, https://edupro.cc/examples/quantum-analogs-compare-the-difference-in-sound-inputs/
EduPRO. 2021. Quantum analogs compare the difference in sound inputs., viewed 09/14/2021, <https://edupro.cc/examples/quantum-analogs-compare-the-difference-in-sound-inputs/>
EduPRO. Quantum analogs compare the difference in sound inputs. [Internet]. [Accessed 09/14/2021]. Available from: https://edupro.cc/examples/quantum-analogs-compare-the-difference-in-sound-inputs/
"Quantum analogs compare the difference in sound inputs." EduPRO, 05/02/2021 Accessed 09/14/2021. https://edupro.cc/examples/quantum-analogs-compare-the-difference-in-sound-inputs/
"Quantum analogs compare the difference in sound inputs," EduPRO, 05/02/2021. [Online]. Available: https://edupro.cc/examples/quantum-analogs-compare-the-difference-in-sound-inputs/. [Accessed: 09/14/2021]
EduPRO. 2021. "Quantum analogs compare the difference in sound inputs." Retrieved 09/14/2021. (https://edupro.cc/examples/quantum-analogs-compare-the-difference-in-sound-inputs/).
"Quantum analogs compare the difference in sound inputs." EduPRO. https://edupro.cc/examples/quantum-analogs-compare-the-difference-in-sound-inputs/. Published 05/02/2021. Accessed: 09/14/2021.
{{cite web|url=https://edupro.cc/examples/quantum-analogs-compare-the-difference-in-sound-inputs/|title=Quantum analogs compare the difference in sound inputs|publisher=EduPRO|date=05/02/2021|accessdate=09/14/2021}}